How to install the Solar Sun Rings?

Each Solar Sun Ring is 1.5 m in diameter. To find the number of Solar Sun Rings you need, see the chart to the right:

Example: For a swimming pool 8m x 4m, you need about 9 rings.

Solar Sun Rings function much better with the inner ring slightly swollen and the outer ring fully inflated.

Please read carefully the following instructions;

Unwrapping a Solar Sun Ring 1: Unpack and unfold
Getting Started – Take the Solar Sun Ring of the box and unfold it. Relaxation – Expose the Solar Sun Ring in the sun for 15 to 30 minutes depending on the intensity of the sun, to relax the wrinkles caused by the packaging.
Inflating a Solar Sun Ring's outer band 2: Inflate the outer ring
Inflation of the outer ring – Inflate the outer ring, but not completely, until it is firm. NB: This equates to 4 or 5 breaths of good range (for adults). Properly close the valve.
Inflating the inner area of a Solar Sun Ring's 3: Inflate the inner ring
Inflation of the inner ring – Inflate the inner ring with one or two breaths of air only (for adults).Close the valve. NB: Do not over inflate the inner ring. This would result in the Solar Sun Ring bomber while it must be perfectly flat.
Scrunching up a Solar Sun Ring 4: Crumple it!
Air Distribution – Air insufler in the inner ring must be evenly distributed so as to separate the two sheets of vinyl. For this, you may  crumple the Solar Sun Ring or place it on the ground and divide the air with your hand.
Solar Sun Rings in place on the pool 5: At the pool!
Using the Solar Sun Ring – The Solar Sun Ring is now ready for use. Place it now on the surface of your pool and just let it float. Magnets placed on each Solar Sun Ring will seek each other mechanically.
What if it won't lie flat? Some common problems
Solar Sun Rings are not quite flat-This is due to over-inflate the inner ring. You will need to deflate. For this use the plastic tube supplied with the product. Solar Sun Ring a perfectly flat measuring 150cm. Measure to check.
Solar Sun Rings in place on the pool Check your solar rings
Adapt over time – let the Solar Sun Rings fit for a few days and then check them. Search for parts of the inner ring that did not properly separate. If so, then again  allow air to be distributed evenly. You should  slightly rejust the amount of air. 

It’s not flat – when a Solar Sun Ring is too inflated the Solar Sun Ring does not appear and outer ring will rise or will fold as a “V” upside down. This also indicates that they do not heat properly. The reason they do not heat up too well when inflated is that the contact of the blue vinyl pool water is very low. The Solar Sun Rings heaters work best when there is just enough air to keep the two  layers of vinyl seperated.